This is a minor annoyance and fixable after installation, but the settings for APU board serial ports is a little frustrating. I also don't know if I should be making this an issue with 2102/2203/2305 repositories instead.
The APU boot firmware runs at 115200 baud, but the Rooter firmware starting with Grub uses 38400.
I like connecting to the serial port to watch the entire boot process. If I set the connection speed to 115200, I can see the boot firmware. But then anything after that requires me to stop my connection and reconnect at 38400.
Now I can go to /boot/grub.cfg and change all the serial port entries from 38400 to 115200.
Is it too difficult to set this up for the APU build to make it 115200 on installation?
This is a minor annoyance and fixable after installation, but the settings for APU board serial ports is a little frustrating. I also don't know if I should be making this an issue with 2102/2203/2305 repositories instead.
The APU boot firmware runs at 115200 baud, but the Rooter firmware starting with Grub uses 38400.
I like connecting to the serial port to watch the entire boot process. If I set the connection speed to 115200, I can see the boot firmware. But then anything after that requires me to stop my connection and reconnect at 38400.
Now I can go to /boot/grub.cfg and change all the serial port entries from 38400 to 115200.
Is it too difficult to set this up for the APU build to make it 115200 on installation?