PS 2 Player Cable Setup Guide

PS Cable assembly

1. If recycling a cable from a broken controller, or if using an extension cable, cut the cable 10-40cm from the plug.
2. Strip 3-5 cm of the outer insulation sleeving from the cable
3. Cut down the red wire
4. Strip 5mm from the remaining wires.
5. Crimp each wire with a female Dupont crimp in line with the Crimping Guide

   PS1/PS2 Dual Port (2 Players or Multitaps) connection diagram

PS1/PS2 Dual Port (2 Players or Multitaps) connection guide

1. Place a jumper cap on row 18
2. If not using a quickswap header, then on row 20, place the jumper cap across the two central pins (20B & 20C) of the row
   If you are using a quickswap header, then use a jumper wire to connect pin 20B to pin 3A
3. Connect the green wire (Port pin 9) of the Player 1 cable to pin 5B
4. Connect the brown wire (Port pin 1) of the Player 1 cable to pin 6B
5. Connect the blue wire (Port pin 7) of the Player 1 cable to pin 16B
6. Connect the orange wire (Port pin 2) of the Player 1 cable to pin 17B
7. Connect the yellow wire (Port pin 6) of the Player 1 cable to pin 19B
8. Connect the black wire (Port pin 4) of the Player 1 cable to pin 19A
9. Connect the grey wire (Port pin 3) of the Player 1 cable to pin 19D
10. Connect the green wire (Port pin 9) of the Player 2 cable to pin 15B
11. Connect the brown wire (Port pin 1) of the Player 2 cable to pin 2B
12. Connect the blue wire (Port pin 7) of the Player 2 cable to pin 13B
13. Connect the orange wire (Port pin 2) of the Player 2 cable to pin 14B
14. Connect the yellow wire (Port pin 6) of the Player 2 cable to pin 8B
15. Connect the black wire (Port pin 4) of the Player 2 cable to pin 2A
16. Connect the grey wire (Port pin 3) of the Player 2 cable to pin 19C or leave disconnected
17. Connections should now resemble the diagram